Step 1

Heat Water to 160°F (70°C).

TIPS:If using a stovetop pot, DO NOT OVERHEAT!
Watch a video on how you can estimate that the water is at 160°F (70°C)

Step 2

Place your BrainVault^® in 160°F (70°C) water for 1 minute and begin programming your BullsEye Bite™ with the Fit Assist Ring (FAR).

TIPS:Place the curved end in your mouth behind your eye teeth (Cuspids) and begin closing until your lower teeth touch the FAR. Tap, Tap, Tap and hold. Do this 3 times.
Watch the video on our website on how to use the Fit Assist Ring.

Step 3

Watching in Mirror, place on upper teeth and align in the mouth by centering the BV logo under your nose.

Step 4

Use your thumbs at the same time to press up to mold to upper teeth and then use fingers to press along the outside towards teeth and gums to create more grip.

Step 5

Leaving the BrainVault^® in your mouth, place the curved end of the FAR in the
Alignment Gap and close as before until your lower teeth touch the FAR - Tap, Tap, Tap, and hold.

Step 6

Remove the FAR and now repeat 3 more times with your teeth - Tap, Tap, Tap
and hold.

TIPS: Watch the video on our website on how to place FAR in Alignment Gap.
The FAR will begin the Bulls Eye Bite fitting process.
As you begin setting the Bulls Eye Bite with your teeth it will feel better and
better with each set of Tap, Tap, Tap and hold. Usually after 3 sets your bite will
feel comfortable.

Step 7

Place the BrainVault^® back in 160°F (70°C) water for 10 SECONDS NO MORE, then remove, place in the mouth, close and hold use fingers to towards teeth and gums again to perfect the fit.

TIPS: To improve fit you can repeat step 7 as many times as you like.
If you are a youth and lose a baby tooth you can re-fit by repeating the process from steps 6 and 7.
If it has been a season since you used your BrainVault^® you can re-fit by repeating steps 6 and 7.